hihcadore 2 yr. ago Thanks! GENERAL TIPS FOR SPRAYING PAINT WITH HVLP GUNS Technical Data Sheet Homestead Finishing Products PO Box 360275 Strongsville, OH 44136-0005 216-631-5309 GENERAL TIPS FOR SPRAYING PAINT WITH HVLP GUNS Spraying paint requires a bit of practice, particularly vertical surfaces. Matt G. (author) from United States on May 23, 2020: At this point, the finish and bond was comprised by over-tinting the BIN primer. Unless you plan on cleaning the cabinets a lot, the satin finish is fine. Even though it's clear, the film has some color to it. I plan to paint with a foam roller (I know spraying is preferred, but my schedule doesn't allow me to rent a sprayer without having to return it immediately after without fear of keeping it for the next three weeks) and sand using my B&D Mouse, using the Sherwin Williams ProBlock and Sherwin Willians Emerald Urethane (when the 40% off rolls around again). For my own sanity, I may spray another test piece with both buckets if the new one turns out fine, just to do another double-check under similar circumstances. My Sherwin Williams store had recommended the semi-gloss finish for cabinets because they said the satin finish is too dull. I've sprayed Emerald enamel many times with all three of my sprayers and never had tailing with a 208 and 310 fine finish tip. Oil primer, or BIN shellac primer, are both great choices for preventing bleed through and getting a strong bond with the surface and paint. Agree that there's a lot of variables as I'm working in a non-controlled environment, so that's why I want to try the new bucket to see if that solves it. Answer: The dry time isn't bad. I'm not familiar with the Wagner sprayer you mentioned, but airless sprayers can usually handle enamel. Answer: Yes, I've sprayed this product in dark grey on cabinets without any challenges. Can I use Emerald Urethane paint to change the color of the cabinets? I've never sprayed this product through an HVLP, but you'll definitely have to reduce the paint in that case. Graco 390 PC 3300 PSI @ 0.47 GPM Electric Airless Sprayer - Stand. Anticipating doing 3 coats of paint, do I need to sand between the 1st and 2nd coat of paint? I have heard that it tends to look flat. "10151", What am I doing wrong!!?? Because airless sprayers handle thicker paint, they are better suited for use against thicker paint than compressed air or HVLP sprayers. The Sherwin Williams Emerald Urethane Cure Time Paint typically cures in 30 days. The ideal sprayer for residential jobs and the best value in small electric sprayers. Rick - I know I am not perfect, but I will keep pressing on toward the goal of becoming all I am called to be. The base color is a bright white. Question: I want to paint my kitchen cabinets gray on unfinished oak, can I use the Sherwin Williams Emerald semi-gloss as a top coat or does it only work on white painted cabinets? If you add too much extender or water, the sheen dulls. Tomorrow I'll be putting everything together, including the new hardware. Graco Finish Pro 9.5 5 Stage HVLP Turbine Sprayer Pro Contractor Series. If the paint is soft and rubbery, it sounds like a cheap wall or trim paint was used, or the cabinets weren't prepped right. There is a difference in dry time and cure time. Emerald can be sprayed easily using either an airless paint sprayer or HVLP spray gun. It's the first time using this paint and also a sprayer. I used Sherwin Williams Emerald urethane trim enamel for bathroom cabinets and the paint and primer both are gummy and come when you rub them. I sprayed two thick coats of Emerald on cabinet wall boxes and had no issues with dripping paint. The customer wished she would have used satin because the finish was too shiny for her liking. Available in complete gun and cup systems and higher production outfits. The more tint, the longer it takes for the enamel to cure, so the finish will be softer longer. Though I haven't done a lot of spraying SW in general, but I have sprayed a fair amount of the ProClassic Acrylic and i have to thin well in excess of recommendations. The oil paint should not be scratching off. I will sand everything down to bare wood, reprime with nontinted BIN, and reapply the Emerald. Also, to be clear I sanded the finish smooth and started fresh each time. I don't know what type he used but it was the eggshell finish. About to do all my cabinets with this paint using the extreme bond primer and emerald urethane on the laminated panels. Dry time means you can recoat or handle it. The paint alone is washable enough without a clear coat, but you can top coat it. The Arena Media Brands, LLC and respective content providers to this website may receive compensation for some links to products and services on this website. Is a certain roller best for this? A separate oil-base primer must be applied over bare wood and stains to prevent bleed-through. Before moisture can adhere to the surface of most products, they must be dried for at least four hours. Engineered for superior atomization in the widest range of materials, Graco FinishPro HVLP sprayers are one of the coolest running, longest life HVLP sprayers on the market today. A mask is definitely needed when working with this product if you're spraying. I'm a homemaker and I loved the finish. The second coat dried in about three hours. Cover Stain oil primer is a good product for this. This 5-stage Turbine motor develops approximately 9.5 psi Incorporated into its design is a proprietary Heat Dissipation Chamber (HDC). Hvlp Spray Gun Parts Repair in Laveen, AZ. I have metal cabinets from the 50s-60s. Each coat dried with the test piece laying down, to give it the best chance of leveling out. The paint is soft at first and needs to harden more before you can clean it with water. If the sprayer wasn't atomizing the paint correctly then your spray fan could have left tails on the edges of it. You can also apply for a Pro charge account at your local Sherwin Williams store to get discount pricing. Your Sherwin-Williams account number that you received from your local store rep. And then apply two coats. The tinting issue is your main problem, but it's probably also too hot and humid in the garage.Try to control the air better with a small portable AC unit with fans and exhaust so the fumes are being filtered out and fresh air coming in. I would prefer the look of satin. 190 0 obj <> endobj Question: Can I use the BIN shellac primer with the emerald enamel over the top? Question: I'm in between the same steps with the same products and I've come across your great post. Can You Spray Sherwin Williams Emerald Paint | Painting Facts If you're painting cabinets, you'll only need two to three gallons anyway, but still, that's a lot of money for paint. Question: What sprayer did you use without having to thin this product? If the BIN primer was tinted too, especially beyond the recommended specs, which I believe is 2 ounces of colorant, this can also slow the drying a lot and cause problems. If you used latex primer, that's likely part of the reason the finish is weak and rubbing off. No need to top coat the paint with a clear coat. If your new to painting or have otherprojectsyou want to work on like paintinga fence or interior then an airless sprayer will be more versatile than the HVLP. I would wait a couple of days, or longer, before placing books or anything heavy on the fresh paint. To do that set the pressure control at its lowest setting and slowly increase it until the paint is completely atomized. Matt G. (author) from United States on May 25, 2019: No problem. Premium paint for windows, doors, trim and cabinets. 0000006810 00000 n Question: We painted (sprayed 2 coats) the kitchen cabinets with a SW satin oil base with kilz as a primer. In my experience, the primer doesn't stick to the surface as good as without colorant. It is more of a professional line, whereas the Emerald is more of a DIY line. It took 0 milliseconds to generate this page. Airless Paint Sprayer is ideal for small paint jobs. Airless paint sprayers work faster than traditional sprayers and roll paint more efficiently. It's a highly durable modified waterborne. Question: Can I use an antique glaze over Sherwin Williams' emerald semi-gloss (I used antique white) and, if so, can I seal it with a coat of polyurethane? It works great on multiple surfaces, including laminate. Close. Sherwin Williams Emerald Urethane Paint I checked the primer - it has bonded to the plywood as expected. Emerald Urethane over Oil? - Professional Painting Contractors Forum In general, I think I did a good job preparing my doors. HubPages is a registered trademark of The Arena Platform, Inc. Other product and company names shown may be trademarks of their respective owners. I flipped the 125 pound cabinet over to paint the front. Matt G. (author) from United States on August 22, 2020: I've never sprayed with the handheld sprayer you used, but those sprayers have very small pumps. Answer: Whether or not primer's needed depends on the surface you're painting. At first, by mistake, I used Emerald interior latex. They say with Emerald you dont need too , that its hard enough. The powder you're seeing is the extra colorant that separated from the pigment in the shellac. We offer on site service in Ohio, West Virginia, and Pennsylvania3601 Library RdPittsburghPA15234. <]>> It will take more time to cure darker colors. This high performance electric airless sprayer will apply all standard architectural primer, paints and coatings efficiently. My painter has been doing this a long time but prefers oil. I am using Emerald urethane paint on interior doors, previously finished with SW Super paint in semi gloss. It looks like I have all of those things you mentioned in your response. Answer: Sand the drip until it's level with the surface. Ideally you should use afine finishlow pressureairless tipto ensure the smoothest finish. Beyond 4 mils, the enamel dry time slows down. xedos, I'm a bit bummed because the rep told me it would be fine in HVLP, but clearly it's not. "8_3074457345618274188requisitionListSelect", For a compressed air HVLP spray gun you can go with a gravity feed or pressure pot. That should be under 4 mils but I could have applied the other two coats thicker. I let the primer harden overnight, scuff sand, and spray two coats of Emerald urethane at 3 1/2 to 4 mils max, allowing the paint to dry overnight between coats. Hybrid enamel takes longer to cure than straight acrylic enamel. If you want to seal your chalk paint, using primer sealer will seal the coating and provide a good bond coat for the trim enamel on top. If fumes are an issue, as an alternative you can shoot Ben Moore Advance. I would also spray it with an airless sprayer, which requires no thinning. How was your experience in this? 0000000016 00000 n Matt G. (author) from United States on August 09, 2019: Yes, BIN shellac primer will seal the MDF doors for your paint. Either size tip is fine, but for doors, the 310 tip is better. This man charges $100 per cabinet door and drawer. more on the differences between the two here. Enjoy my process of spraying cabinet doors with an HVLP and i take you through the spray day. The level of sheen also depends on prep and the number of coats too. With one coat, it's more dull. Any suggestions what went wrong? You might consider renting a professional sealed sprayer that can safely spray flammable material, or buy one. Hi Matt, I've just finished the second coat of my cabinets with the SW Emerald Urethane in semi gloss. The regular price for Emerald Urethane enamel starts at $109 per gallon. Regular joint compound, or Aqua Coat, work great and sand easy. If it's already painted, you don't need to use primer. I've kept the old cabinet boxes, as I completely remodeled my home and was trying to save where I could - I will be cleaning and sanding the boxes but the doors are unfinished pine/MDF ready for paint. We heat our spray room with a normal furnace but it can't keep up with the the temp when the fan is running. This primer doesn't react well with tint and can only be tinted with a max of 2 ounces of universal colorant. Dry time is 30 minutes to sand and it sands very well. If you paint Emerald over the latex, it won't help anything. After priming and sanding use bondo red glaze to fill any flaws. I know Wooster has some good brushes too, but I've never used them. Question: I plan to paint laminate cabinets, do you recommend a primer? Even thinning it like I do, there is a fine line between just right and runs/globs. It will take an extra coat of your navy enamel to cover over the white primer, but you won't have any durability problems. Innovations in design utilizing high quality unique materials and efficient manufacturing process result in a precision built airless sprayer and accessories that last longer than any other unit in their class. The paint levels, but holds in place without sagging, which I really like.
Do Used Coffee Grounds Deter Squirrels,
Suspicious Death Kingsport Tn,
Capula Tail Risk Fund,
Articles S